If the Internet Port IP Address is showing as 0.0.0.0, please see How to powercycle your home network to refresh your network and you should be able to receive an IP address from your ISP. įor older routers with the Smart Wizard UI, you will be able to see Router Status under Maintenance on the left blue panel. To check the Internet IP address, click ADVANCED >Administration>Router Status.Note: If you have an older NETGEAR router with the Smart Wizard UI (as shown in the screenshot below), click Basic Settings under Setup on the left blue panel. For most cable Internet connections, follow the settings shown below then click the Apply button. If you still cannot access the router, please see How do I log in to my NETGEAR home router?.Otherwise, a factory reset is needed to restore the router to factory defaults. To perform a factory reset, see Restoring a NETGEAR home router to the factory default settings If playback doesnt begin shortly, try restarting your device. Please try other passwords that you might have changed to. How to Change/Clone MAC Address of any Wi-Fi Router Som Tips.
If the default username and password is not working, you might have changed the password.The username and password are case-sensitive.The default username is admin and the default password is password.You are prompted to log into the router.
Navigate to the wide-area network (WAN) settings page or a similar settings page (each router may be different.) Once there, look for an option to change the MAC address. If you are lost, check the instructions that accompanied your router. Check your devices to make sure you can get online.Īccess the router’s admin panel via a web interface (browser address bar) or by opening up dedicated firmware software. Make sure your Internet is connected properly, ensuring that the Ethernet cable is going from the modem to the router and that there is an available wireless connection for connected devices. Luckily, this is not an overly difficult task and certainly not as frustrating as, say, learning how to disable IPV6 on a router. When you revert your router to its default settings, the MAC address will also reset to the original setting.